- After a lot of thought and help from elsewhere, the camshaft was found to be needing a replacement due to incorrect storage and so the fun began. Finding the right camshaft was pretty straightforward,...Lee mas
- As for CUB, I always use High Camshaft when I do bore up. 。So what does High Camshaft change? → High Camshaft is a component that changes the power output characteristics in a large, crude way.What is...Lee mas
- I had previously purchased a 75cc Bore Up Kit and used the OEM product for the camshaft, but when I used the High Camshaft with the 75cc Bore Up Kit this time, the engine clearly became a high-revving...Lee mas
- I am very glad that I had the opportunity to purchase this camshaft for my Monkey. After installing a new clutch with the flywheel, the engine power became somewhat lacking. But after installing this ...Lee mas
- I'm on the way to improve my HONDA Little Cub. The relative values of the stars were changed, which led to a loss of power in fourth gear. To eliminate this problem, I decided to use the products of m...Lee mas
- I am a 68 year old man, but I was able to install it. 75cc Bore up, but I was not satisfied with the power & minus;, so I installed the High Camshaft recommended by KITACO. The intake and exhaust may ...Lee mas
- "Приобретал для HONDA SUPER CUB 50 CUSTOM.Артикул детали: 300-1083100, производитель KITACO.Распределительный вал приобрел после увеличения мощности с помощью комплекта для увеличения мощности (KITACO...Lee mas
- It is necessary to use the engine with bore up to around 10000rpm. This is an essential part to make the engine run properly up to around 10,000 rpm. When replacing the Camshaft Sprocket Knock Pin, us...Lee mas
- I installed it on my Honda Jazz, and the comparison with the OEM is as shown in the photo (Right OEM, Left product).It's hard to judge the performance of a single item since I had to replace the sproc...Lee mas
- It is a must for Bore up.I can now do it without Stress.It's easier to drive in town.Lee mas
- Used with the LITTLE CUB 50cc High-compression Piston + PB16 Carburetor.I chose this High Camshaft made by KITACO because the High-compression Piston was made by KITACO and it was confirmed that there...Lee mas
- [Was there anything that disappointed you?NoneAs expected with Bore upDo you have any wishes or improvements you would like to make for the Manufacturer?[Do you have any products to compare it to?SP T...Lee mas
- I wanted to turn it up firmly after Bore up and I bought this product I got the impression that the previous VERSION wasn't well received, but the SPECIAL Knife I bought it because I thought it was od...Lee mas
- As per the product information, it has good extension at high rpmIt was introduced along with the 75cc Bore up, but the evaluation with Single Body and Bore I don't know how it compares with up onlyHo...Lee mas
- 75cc KITACOLight bore up to High Camshaft, Normal The muffler and normal cab alone did 78 km/h. Sprocket did 17 T:32T Now that I've almost figured out the highest speed, I'm going to go a little low o...Lee mas
- It doesn't increase Torque, but it seems to generate power at RPM Normal muffler, Normal muffler, Normal Values in cabLee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING