[Material]
Cuerpo de la caja : Aluminio (alumita negra)
[Dimensiones (aprox.)].
este aparato : 22.3X37.8X36.5
enchufe : Φ3.5
Contenido de la configuración] (Consulte el manual de instrucciones.)
Kit de conexión a la alimentación de accesorios X1
Sub-arnés X1
[Tiempo de instalación]
Depende del vehículo
[Período de garantía del fabricante]
6 meses (o hasta 5000km después de la instalación)
*El termistor PTC se interrumpe por el calor de la corriente, y se convierte en una temperatura muy alta por la cantidad de corriente y el tiempo transcurrido después de la interrupción. En este caso, el termistor PTC puede deformarse o fundirse, lo cual es muy peligroso.
*No instale la unidad en un lugar donde pueda sobrecalentarse.
*La unidad principal es resistente al agua, pero es necesario tratar la parte de los terminales para que no quede expuesta al agua.
*Aunque este producto tiene una alta potencia de 20A, no todos los vehículos pueden ser utilizados con 20A. Dependiendo del vehículo, del estado de la batería y de otros factores, la carga de la batería puede aumentar, lo que puede hacer que la batería se quede sin energía.
*Este servicio supone que usted es un mecánico calificado a nivel nacional que tiene conocimientos generales y habilidades de mantenimiento de motocicletas y que ya tiene las herramientas necesarias.
*El color del producto puede variar dependiendo de las condiciones fotográficas, el monitor, el tamaño del lote y los lados izquierdo y derecho del producto.
*Todas las conexiones, como los conectores, no son impermeables.
*Se requiere una conexión a la fuente de alimentación de accesorios para los relés.
*Por favor, compruebe el diagrama de cableado del vehículo y verifique qué terminal del interruptor de la luz de freno se debe insertar antes de la instalación.
*Tenga en cuenta que las especificaciones del producto pueden estar sujetas a cambios debido a la conveniencia del fabricante. Por favor, entiéndelo.
[Material]
Case body: Aluminum (black alumite)
[Dimensions (approx)]
Main unit: 22.3 x 37.8 x 36.5
Bullet terminal: Φ3.5
[Components] (Refer to the instruction manual)
・Accessory Power Supply Connection Kit x 1
・Sub Harness x 1
[Installation time]
Depends on the vehicle
6 months (or up to 5000km of riding after installation)
*PTC thermistors are cut off by the heat of the current, and become very hot depending on the amount of current and elapsed time after cut off.In this case, it may deform or melt the main unit, which is very dangerous. Remove the interrupted device from the main unit as soon as possible.
*Do not install in a place where heat is likely to accumulate because the main body generates heat.
*The main body is waterproof, but the terminal part should be treated so that it is not exposed to water.
*The output power is as high as 20A, but not all vehicles can be used with 20A.Depending on the vehicle, battery condition, or other factors, the load on the battery may increase, which may cause the battery to run out of power.
*The color of the product may vary depending on the shooting conditions, monitor, product lot, and left and right of the set product, but returns or exchanges is not accepted.
*Connecting parts such as crimp terminals are not waterproof.
*Connection to the accessory power supply for the relay is required.
*Please check the wiring diagram of the vehicle and confirm which terminal of the brake lamp switch is to be interposed before installation.
*There may be changes in product specifications due to the manufacturer's reasons.