- Encaja:
- SUZUKI GSR250 14 GJ55D
- SUZUKI GSR250 14 GJ55D F 14 (L4) GJ55D
- SUZUKI V STROM 1050 23 8BL-EF11M
- SUZUKI V STROM 650 23 8BL-C733M
- SUZUKI BURGMAN200 14 CH41A (CH41A) 14
- ...y más.
I replaced 2 red Daytona oil cap on Suzuki V-strom 1000 ABS and Hayabusa 1300R. it come with o-ring and easy replace OEM plastic cap, cheap price, red anodize look cool.Lee mas - Encaja:
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Front[Required quantity]2
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Rear[Required number]1
- HONDA XLR250R 91-94 (MD22)[Place of use]Rear[Required number]1
- HONDA CBR250R 88-89 (MC19)[Where used]Front[Required number]1
- HONDA VFR400R 87 (NC21)[Place of use]Front[Required number] 4
- ...y más.
A bit longer than intended for the front caliper. Maybe the pin I received is for the rear. But it fits properly on the front caliper anyway.Lee mas - Encaja:
- HONDA CB1100
- HONDA CB1300SB
- HONDA CB1300SF
- HONDA CB500
- HONDA CB750
- ...y más.
Used at Touring destinationNo problem even if it runs out at worst… I like to use it at this level.If you can afford it, buy a good Seat.Lee mas - Encaja:
- KAWASAKI Z800 13-16
- KAWASAKI ZZ-R1200 02-05
- KAWASAKI GPZ600R 85
- KAWASAKI ER-6f 07-10
- KAWASAKI ER-6n 06-14
- ...y más.
SIZE 3L purchased400X with OEMRear Carrier (NC56) Attached toJust fit!Lee mas - Encaja:
- SUZUKI GSX250R 87-88
- SUZUKI GSX250R 21 ABS DN11A
- SUZUKI GSX400 94-07
- SUZUKI GSX1300R HAYABUSA 99-17
- SUZUKI GSX1400 01-07
- ...y más.
Wiring is also possible, so it's good for sports drivers.Lee mas - Encaja:
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Front[Required quantity]2
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Rear[Required number]1
- HONDA XLR250R 91-94 (MD22)[Place of use]Rear[Required number]1
- HONDA CBR250R 88-89 (MC19)[Where used]Front[Required number]1
- HONDA VFR400R 87 (NC21)[Place of use]Front[Required number] 4
- ...y más.
today i change the rear brake rotor and overhaul the caliper. the brake pin has seriously rusted and damaged so i cleaning all the surface of caliper and (not changed caliper piston...and Oring) and l...Lee mas - Encaja:
- SUZUKI GSX1400 07 Frame No.】GY71A-103926 or later GY71A
- SUZUKI GSX1400 06 Frame No.】GY71A-103563 or later GY71A
- SUZUKI GSX1400 05 Frame No.】GY71A-103061 or later GY71A
- SUZUKI GSX1400 04 Frame No.] GY71A-102248 or later GY71A
- SUZUKI GSX1400 03 Frame No.] GY71A-101960 or later GY71A
- ...y más.
I thought I was sitting comfortably in the middle.Before I knew it, I was sitting closer to the front until my crotch hit the Tank....A common OEMSeat complaint about the GSX1400.GSX1400Owners oversea...Lee mas - Encaja:
- SUZUKI GSX-R750SPR 94-95
- KAWASAKI ZX-12R 00-03
- KAWASAKI ZRX1200S 01-04
- KAWASAKI ZRX1100 97-00
- KAWASAKI ZRX1200R 01-08
- ...y más.
Installed on a Tokico 6POTCaliper.It originally contained a Tokico OEMPad, which was replaced with this product.The effect of the Brake was a bit milder than the Snap effect.(only compared to TokicoOE...Lee mas - Encaja:
- HONDA CB400F 13 ABS
- HONDA CB400F 13
- HONDA BROS400 88-90
- HONDA CB-1 89-91
- HONDA 400X 13-21 ABS
- ...y más.
Used in Motorcycle storage area in shadow of building but exposed to wind, rain and sunlight.It is hung over the Main's Cover for protection and blindfold.After two years, it was replaced because of f...Lee mas - Encaja:
- SUZUKI V-strom1050 XT 20-21 EF11M M0/M1
- SUZUKI Impulse 04-08 GK7CA K5/XK5/K7/XK7/XK7
- SUZUKI V STROM 1050 23 8BL-EF11M
- SUZUKI V STROM 650 23 8BL-C733M
- SUZUKI V-strom1050 20-21 EF11M M0/M1
- ...y más.
I chose this one because it was the cheapest, and it is sufficient.Lee mas - Encaja:
- HONDA CB400F 13 ABS
- HONDA CB400F 13
- HONDA BROS400 88-90
- HONDA CB-1 89-91
- HONDA 400X 13-21 ABS
- ...y más.
Purchased using Point.As an individual, Waterproof is enough.Included Parts:Belt for wind resistance and heat resistant pad are nice and easy to install without wasting time.Lee mas - Encaja:
- SUZUKI GSR250 14 GJ55D
- SUZUKI GSR250 14 GJ55D F 14 (L4) GJ55D
- SUZUKI V STROM 1050 23 8BL-EF11M
- SUZUKI V STROM 650 23 8BL-C733M
- SUZUKI BURGMAN200 14 CH41A (CH41A) 14
- ...y más.
I used this product for a casual Oil Filler Cap Custom, it's easy to replace with OEM Product and the Aluminum Cut-out has a nice texture.Lee mas - Encaja:
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Front[Required quantity]2
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Rear[Required number]1
- HONDA XLR250R 91-94 (MD22)[Place of use]Rear[Required number]1
- HONDA CBR250R 88-89 (MC19)[Where used]Front[Required number]1
- HONDA VFR400R 87 (NC21)[Place of use]Front[Required number] 4
- ...y más.
First, let me say that this is a special case based on a combination of several conditions.After cleaning the Caliper, I put it back together, tightened the pad pin, and was finishing up by tightening...Lee mas - Encaja:
- YAMAHA MT03
- HONDA CB1300 SUPER FOUR SP 20 SC54-250
- HONDA Forza300
- HONDA CB1300 SUPER BOLDOL SP 20 SC54-250
- YAMAHA YZF1000 THUNDER ACE
- ...y más.
I bought this for my ZZr1400 with top case, but the size is too small to use.There is no room at all in the Large size of the Cover.Lee mas - Encaja:
- SUZUKI V STROM 1050 23 8BL-EF11M
- SUZUKI V STROM 650 23 8BL-C733M
- SUZUKI V-strom1050 20-21 EF11M M0/M1
- SUZUKI BOULEVARD800 05-06 VS56A K5/K6
- SUZUKI V-strom1050 XT 20-21 EF11M M0/M1
- ...y más.
The Customized Exhaust System was not allowed to replace the Element, but with the Daytona Oil Filter, it was possible to replace the Element without removing the Exhaust System.Lee mas - Encaja:
- KAWASAKI Z800 13-16
- KAWASAKI ZZ-R1200 02-05
- KAWASAKI GPZ600R 85
- KAWASAKI ER-6f 07-10
- KAWASAKI ER-6n 06-14
- ...y más.
[How is it used?It is outdoors to the extent that it blows in a little.Was the one you received as per Image?I think it is as shown in the product photo.How was your experience with it?The rear tire i...Lee mas - Encaja:
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Front[Required quantity]2
- HONDA X4 TypeLD 97-01 (SC38)[Place of use]Rear[Required number]1
- HONDA XLR250R 91-94 (MD22)[Place of use]Rear[Required number]1
- HONDA CBR250R 88-89 (MC19)[Where used]Front[Required number]1
- HONDA VFR400R 87 (NC21)[Place of use]Front[Required number] 4
- ...y más.
For those who want to upgrade with OEM replacementIt's hard to lick, hard to decay, and also cool.Recommended for people who ride Honda motorcycles, but be careful with the length.Lee mas - Encaja:
- KAWASAKI ZXR250R 90 [Frame No.]ZX250A-301501 or later
- KAWASAKI ZXR400 89 [ZX400] [Frame No.]ZX400H-000001 or later
- KAWASAKI ZXR250 95 [Frame No.]ZX250C
- KAWASAKI ZXR250 99 [Frame No.]ZX250C-020001 or later
- KAWASAKI ZXR250R 89 [Frame No.]ZX250A-300001 or later
- ...y más.
I've been sticking with the Tokico 6 pods. This time I adopted CaliperOverhaul and baked paint instead of OEM. I think it's a good corrosion protection. I've heard that some people use seal tape to pr...Lee mas - Encaja:
- KAWASAKI Z800 13-16
- KAWASAKI ZZ-R1200 02-05
- KAWASAKI GPZ600R 85
- KAWASAKI ER-6f 07-10
- KAWASAKI ER-6n 06-14
- ...y más.
[How is it used?I'm using it on my MainMotorcycle XJR1300C, and I'd say the 3L size is about right or a little large.I chose this size because the normal XJR1300 is 3L size and the old model Black cov...Lee mas - Encaja:
- HONDA CB400F 13 ABS
- HONDA CB400F 13
- HONDA BROS400 88-90
- HONDA CB-1 89-91
- HONDA 400X 13-21 ABS
- ...y más.
I was using Black's LLSize.The thickness of the cover is reasonable, but it comes with a heat resistant cloth for the exhaust system and a belt for wind protection.The motorcycle cover was easy to use...Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING